This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

In some models for water surfaces in the tanks by default are given elevation in the other are given levels. How does it (the type - elevation/level) change?

Dear Colleagues,

In some models in WtG for water surfaces in the properties of the tanks by default are given an elevations, in the other models are given the levels. How does it (the type - elevation/level) change? 

Parents
  • You control this by setting the Tank element property "Operating Range Type" to either Elevation or Level. You can set this globally or tank-by-tank. Reservoir elements only have the Elevation setting because they represent a HGL.

    Answer Verified By: Boyan Borisov 

Reply
  • You control this by setting the Tank element property "Operating Range Type" to either Elevation or Level. You can set this globally or tank-by-tank. Reservoir elements only have the Elevation setting because they represent a HGL.

    Answer Verified By: Boyan Borisov 

Children