ref: https://communities.bentley.com/products/hydraulics___hydrology/f/haestad-hydraulics-and-hydrology-forum/151398/extended-period-simulation-in-watergems/
Hi, I am doing an extended period simulation using the watergems manual that comes with watercad. On clicking validation, the software says ' Problems were found during validation ' Please advise.
Hi Nyakundi Kevin,
Did you see any user notifications which shows what problems were in your model?
Generally you should check for some possible errors such as disconnected junctions, extremely low pressures, incorrectly configured pumps or valves.
Also check if the "User Notifications" dialog box is open. When you see such a message, open the "User Notifications" dialog box to view what kind of errors the software found.
If you can get a snapshot of the user notifications we might be able to hep you better.
Regards,
Yashodhan Joshi
I have figured out the issue. I had not input the correct figures in the patterns manager i.e. the multiplier for the last time was not the same as the starting multiplier. The notification panel was not showing but i realized it was hidden at the bottom of the drawing. Thank you for your response.
Apologies, I just noticed your second, duplicate thread. I have joined the two threads together. See my previous reply for the "reset workspace" option to restore the dockable managers.
Jesse DringoliTechnical Support Manager, OpenFlowsBentley Communities Site AdministratorBentley Systems, Inc.