Bentley Communities
Site
Search
User
Site
Search
User
Product Communities
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
BENTLY - SEWERGEMS CONNECT EDITION UPDATE 1
Sign In
State
Verified Answer
Locked
Locked
Replies
3 replies
Answers
2 answers
Subscribers
81 subscribers
Views
543 views
Users
0 members are here
Phil Chouinard
Bently community
SewerGEMS
SewerCAD
Bentley SewerGEMS
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion
BENTLY - SEWERGEMS CONNECT EDITION UPDATE 1
Offline
G Gurumoorthy
over 3 years ago
Ques-1 :
If i have taken from Center line of the road network in Autocad dxf file and Imported in Sewergems software using Model Builder. Now, The Network of the centre line pipe, lots of bend came in the network. One by one we can select the pipe and remove the Bends. But, It is possible to select the overall pipe and remove the bend?.
Ques - 2 :
Without draw the network of the pipe line (every 30m Inetrvals). It is possible to make the Network every 30 m intervals using any methods in Sewergems or ArcGIS or AutoCAD?.
Note : i
have faced this problems in the Short term Period of the Project.
Ques - 3 :
I have 1000 reverse nodes. I cant select each one by one pipe and Change the reverse node means, it will take more time. It is possible to select 1000 pipes and rectify the Reverse Node any methods.?
Ques - 4 :
I have finished my design. Now, i have to taken the Hydraulic Statement. But, In this Hydrulic Statement Uniform slope will not come. It is possible to make the Uniform Slope?.
Ex: Conduit 1 to 5 - Diameter - 150mm and Slope is 100, Next Conduit 6 to 10 - Diameter - 150 and Slope is 80, Next Conduit - 11 to 15- Dia - 150 and Slope is 100.
Inbetween conduit of the slope is 80. It is Possible to make uniform same slope will come?.