This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wet Well Elevation (Initial) Error

Dear Colleagues,

I am getting this error while switching between different scenarios "Invalid wet well operating range. (Minimum < Initial < Maximum)." Pressure Engine". The error is because the model automatically update/change the Elevation (Initial) of wet wells. Every time I correct it and again it changes automatically. Is there any option to fix Elevation (Initial) or all elevations for all or specific scenarios?

See in the below screenshot, where the actual value entered for Elevation (initial) was 532.5 m but it changes automatically to 535.0 m.

Regards,

Parents Reply Children
No Data