This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

alternative and senario in watergems

hello

I create Physical alternative named "Physical  child "and Active Topology alternative named "Active Topology child" in Water GEMS in my child senario. when  I add a PRV to my child senario it spilt the pipe in child senario.

In base senario the prv is inactive and it's good but because of spilt pipe in base senario i confront error of pipe.

Is it any solution to add PRV in child senario and have no effect on the base scenario(not spilit pipe , not active PRV)?

In short, I will add PRV  to the project without Spilit pipes in the base scenario

In the other word i want wjen i add PRV4 in child senario i haven't spilit pipe (p-7(1) and p-7(2)) in base senario that show in below picture

thanks

Parents
  • Hello Ehsan,

    Try adding a parallel pipe connecting the same points and add the PRV on that point. In the child scenario make this pipe and PRV "active" and the original "inactive". In the base scenario make the original pipe "active" and the parallel pipe with PRV as "inactive".

    In child scenario your connection should be like this;

    Notice that original pipe P-1 is greyed out / inactive in this scenario

    For the base scenario your setup would look like this;

    Notice that the parallel pipe with PRV is now inactive.

    For more details on controlling active topology see this article: Active Topology Management

    Hope this helps.


    Regards,

    Yashodhan Joshi

  • Thank you for your response

    It is a good solution and I use it but I hope we have a better and faster solution. because in each case we must adjust dimeter, material, hazen wiliam and extra. Is that any solution to duplicate a pipe or create fast parallel pipe? or other solutions

    thanks

Reply Children