This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Stormcad for Microstation Connect Edition

I am setting up a stormcad model. When I start drawing the catchment areas, stormcad locks up, stops operating and terminates the program. Has anyone else had this problem. If so, what was your solution?

Parents
  • Jesse,
    Thanks so much for your help on this.  I am very impressed with your attention and persistence to solve this issue.  You need a raise!
     
    Rick Saunders, PE
    Saunders Engineering Consultants, Inc
    104-C Gunn Road
    Centerville, GA 31028
    (478)-953-1228 Office
    (478) 954-1248 Fax
    rsaunders@saunderseng.com
     
Reply
  • Jesse,
    Thanks so much for your help on this.  I am very impressed with your attention and persistence to solve this issue.  You need a raise!
     
    Rick Saunders, PE
    Saunders Engineering Consultants, Inc
    104-C Gunn Road
    Centerville, GA 31028
    (478)-953-1228 Office
    (478) 954-1248 Fax
    rsaunders@saunderseng.com
     
Children