This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Batch Scenario Run Problem

Dear Bentley Team,

I have model three scenarios  rapid valve closure, Valve Closure and Slow Valve Closure and developed three different Transient Closure Pattern. When I am computing with batch scenarios of  all three.  All my results are same, when I compute scenario separately then results different from each other which make sense. I think I am doing mistake in Alternatives (Initial Settings) because it  is computing with that  pattern of valve which is selected in last. I have attached picture of batch run. 

Thanks & Regards,

Syed