This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WaterCAD/WaterGEMS for water mass balance calculations?

Is it possible to use WaterCAD/WaterGEMS for water mass balance type calculations? We have the reservoir inlet flow meter and the water level data for a 1 ML tank and I am trying to work out the corresponding outflow from the tank as there is no flow meter on the outlet. I set up a model (attached) with a junction representing (enforcing) the inflow and a reservoir with a head pattern representing the water level in the tank but that's as far as I was able go. The results are still very much dependent on the hydraulics i.e. inlet & outlet pipe diameters, lengths, roughnesses etc. Obviously, I can set up and do the water balance calcs in Excel but it would be a lot easier if there was a way to do in WaterCAD/WaterGEMS perhaps with the potential to deal with even more complex water balance problems.Water balance example.wtgpkg.zip

Parents Reply Children
No Data