Hello Bentley Community,
I am trying to lift wastewater load using wetwell and pump and force main, but I need to put manhole before wetwell and put the load for spill in wetwell. Is there anyway that I can put my load directly to wetwell and the pump to second point?
Muhammad,
Which product and version are you using, and which solver? For example SewerCAD CONNECT Edition 10.03.04.53, or the Implicit solver in SewerGEMS CONNECT Edition 10.03.04.53.
You should be able to enter sanitary loads directly in the wetwell properties without having to use a manhole and conduit upstream. For example for SewerGEMS you can modify the included Sample-3 or Sample-4 (located in the Samples subfolder within the SewerGEMS installation folder) and you'll see that it computes without a problem.
If you have tried this and encountered a problem, please elaborate and/or provide a copy of the model for review: Sharing Hydraulic Model Files on the OpenFlows Forum
Regards,
Jesse DringoliTechnical Support Manager, OpenFlowsBentley Communities Site AdministratorBentley Systems, Inc.
Jesse,
I'm using SewerCAD CONNECT Edition 10.03.04.53. Thanks for your reply and its working fine.
This information has been added to following wiki, for simplification.
Understanding the Sanitary Load Control Center and Inflow Control Center
Sushma Choure
Bentley Technical Suppport