This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pump Head & Flow WaterGems

I need technical assistance for the attached cooling water model

KSP-Cooling Water System.wtg

Process Brief: The cold water from the elevated tank (actually a cooling tower) is pumped (fixed speed pump) through heat exchanger (chiller) and back to the tank. There are 7 cooling towers. 7 pumps and multiple heat exchangers all connected through common header arrangement. The model is attached. Now the task is to evaluate the head developed by the pump for this process.

Please provide your inputs for following:

  1. I understand that Water gems-Pump element does not have the feature to evaluate the head based on flow only.  I have to give an arbitrary pump-head co-relation in-order to finalize the pump head. Please confirm
  2. The required pump flow is 14,300 usgpm, so I had set up flow demand in the tank as 14,300 usgpm and the flow through FCV as 14,300 usgpm. The pump head is approx 35 m, which I think is not correct, because the fixed pressure drop across heat exchangers, suction diffusers (modelled as GPV) = 1.22+2.23+2.59+1.22 = 7.26 m and the static head difference between the tank initial elevation and tank top pipe inlet is 16.93-7.68=9.25 m. Therefore the total head required by the pump = 7.26+9.25+losses in the pipe = 16.51+piping pressure loss. I did a quick calculation in excel to evaluate the frictional pressure loss which is 5.5 m. Therefore the total head of the pump should not be more than 16.51+5.5= 22.01 m. Can you help in finding the error in the model.
  3. I had provided the demand for the tank as 14,300 usgpm, however in the tank result sheet I see that the flow in & flow out does not match to 14,300 usgpm

Thanks

Pratik