water cad problems

The warmest greetings to you all!!

Today i am in trouble while computing water CAD analysis. i have basically two spring source and i provide a collection box which directs them to service reservoir or Tank in our case. However, after putting every important parameters and finally making it to validate, it says no problem was found. where as, after computing the analysis, the arrow that indicates the flow shows, the flow is again back to its initial sources. Actually  its not my desire to design the water from service reservoir to spring source. i want to design the flow from tank to down streams through gravity. Is there anyone who helps me please! 

regards!!

Parents
  • Water flows down the hydraulic grade line. Therefore, a good way to debug your problem is to draw the hydraulic profile along some path through your system. Use the profile tools View > Profile and you'll be able to find the problem.

    In your case, your source my be hydraulically lower than the tank or some similar error. If the tank is higher than the source, you may need a pump. If there is another source at a higher HGL than the spring, it can back up the spring.  

    It should be easy to identify the problem and correct the error.

Reply
  • Water flows down the hydraulic grade line. Therefore, a good way to debug your problem is to draw the hydraulic profile along some path through your system. Use the profile tools View > Profile and you'll be able to find the problem.

    In your case, your source my be hydraulically lower than the tank or some similar error. If the tank is higher than the source, you may need a pump. If there is another source at a higher HGL than the spring, it can back up the spring.  

    It should be easy to identify the problem and correct the error.

Children