Hello:
I have a Watercad (Connect Edition) model where one of my tanks will fill up to about 95% full, and then continue to slowly fill up over time even though i have a FCV before the tank that should prevent any flow from entering the tank when it reaches the 95% full mark.
I will submit the model files for your reference after this post is created.
The tank in question is TANK-B. Run the EPS Run scenario, and view a graph of water level of the tank to see results I mentioned.
Thanks,
Jose
Jose Ortiz,
I'm still looking at your model but I am not seeing any Flow out of Tank B but I do see the Hydraulic Grade rising.
I'm going to consult with Development about why I see that and get back to you.
Here is a good reference article for Graphing flow coming out of a tank.
I'll post again here after talking to Development.
Thank-you,Larry