This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pond curve elevation-volume in CivilStorm

Hello!

I just had one question about setting the paremeters of a pound:

I am creating a model of a urban network including reservoirs. When I make the simulation the pond's volume and the elevation computed (as result) don't correspond to the elevation area/volume curve setted before. First I thought it was an error of setting paramters but then I looked in the quick start lessons examples and there were the same problems. The elevation area/volume curve is only respected in the simulations when setting the elevation of the pond at a zero elevation.

the invert value of a pound is setted by the lowest elevation of the pound elevation area/volume curve? there is an available "invert parameter" located in the flex table but it doesn't seem to be taken into account.

 

Another question, I'm using the 05.03.2008 [08.09.26.17] is there any patches or update for it and where can I get them?

Thank you for the help!

regards