This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pump reports 0 gpm.. need a fix

Hello,

I've inherited a water system file and am trying to figure out the cause for a bunch of low pressure junctions. There is a pump nearby that reports 0 gpm, so it's obviously not helping my system. I can't figure out why there is no flow between J-33 and J-37. Here's a picture of my system. Red dots are the low pressure junctions. Any thoughts? FYI I am very new to WaterCAD, barely learning the basics here.

Thanks,

Jen