• Re: Model Calibration...

    Dr. Walski's report of my appearance has not been greatly exaggerated- James there is a plug for the Haestad training in the blog area... titled Haestad Learning Content - Who opened the valve on learning ". The Bentley Institute has concentrated training…
  • Culvert Failure Analysis -- Which Program?

    I am looking to model a 72-inch CMP storm drain failure due to excessive thrust I suspect. I want to simulate the pipe failure, sink hole formation, the water surfacing, and the subsequent scouring. It's a bit of a tall order and will require substantial…
  • Re: modelling with 2 fire events

    Grgulla, Briefly, you mentioned it was a requirement to model 2 fire events - understood that it is a requirement - a bit conservative but I wanted to mention a few other points to consider when modeling 2 fires simultaneously- This will obviously drive…
  • Re: Darwin Calibrator

    Didi, can you help out with some clarification on your question, are you working out a workshop and trying to get the results that are part of the workshop? or Calibrating using Darwin Calibrator for an actual system? If you are Calibrating for a real…
  • SewerCAD/GEMS and SCADA Connect

    Hello everybody, Does anyone knows if SewerCAD/GEMS supports connection with data of a SCADA system through SCADA Connect? Thanks Bill Prassas
  • Animations in WaterCAD

    Good Morning, I am using WaterCAD v8i and i need to present work i did earlier. Can anyone tell me how to save or represent the EPS animation or other animated waterCAD things like Graphs, profiles etc. Thanks in advance and hope someone will help…