• Como se representa un pozo subterraneo como fuente de abastecimiento en watergem

    Buenas tardes, podrian explicar cual es la mejor manera para representar un pozo de aguas subterranea en watergems o watercad? Necesito saber como modelar 8 pozos que son la fuente de abastecimiento de una red de acueducto. Gracias
  • Bentley Hydraulics & Hydrology Special Interest Group Virtual Workshop – December 21 – You’re Invited!

    Mark your calendar for Wednesday, December 21, to attend the monthly Bentley Hydraulics & Hydrology Special Interest Group (SIG) virtual workshop. Focus will be directed to Fire Flow – Understanding the Fire Flow Analysis Functionality of WaterCAD and…
  • Re: Model Calibration...

    Dr. Walski's report of my appearance has not been greatly exaggerated- James there is a plug for the Haestad training in the blog area... titled Haestad Learning Content - Who opened the valve on learning ". The Bentley Institute has concentrated training…
  • Re: modelling with 2 fire events

    Grgulla, Briefly, you mentioned it was a requirement to model 2 fire events - understood that it is a requirement - a bit conservative but I wanted to mention a few other points to consider when modeling 2 fires simultaneously- This will obviously drive…
  • Re: Darwin Calibrator

    Didi, can you help out with some clarification on your question, are you working out a workshop and trying to get the results that are part of the workshop? or Calibrating using Darwin Calibrator for an actual system? If you are Calibrating for a real…
  • How to find Water at the Bentley LEARNing Conference May 13-16?

    Here is a list of the water sessions going on at this year's Bentley LEARNing Conference in Phili! BCW2LC1 ‐ Introduction to Bentley Hydraulics and Hydrology Products Tues 2-2:45 pm Lead by H&H AE, Mike Rosh …
  • WaterCAD age calculation fails

    I have run into a recent problem. I've been trying to do a age calculation on our water system and for some reason the largest duration I can calculate is 128 hrs. If I change it to 129 hrs the calculation fails and I get an error: Calculation Engine…
  • Unusual Flow Results

    I'm getting some unusual results and am unable to find a solution. I'm trying to better calibrate our model near an area where 2 pressure zones meet. I've performed a fire flow analysis and tried to confirm the pressures and flow in that area. A flow…
  • Re: Watercad - Looped System Modeling

    Great answers Kim, I have a few approaches to add - first let me rank the approaches in preference. 1) The full model with all controls is always best to determine the most accurate performance (this involves a good deal of set up, controls, and…