• Re: Darwin Calibrator

    Didi, can you help out with some clarification on your question, are you working out a workshop and trying to get the results that are part of the workshop? or Calibrating using Darwin Calibrator for an actual system? If you are Calibrating for a real…
  • SewerCAD/GEMS and SCADA Connect

    Hello everybody, Does anyone knows if SewerCAD/GEMS supports connection with data of a SCADA system through SCADA Connect? Thanks Bill Prassas
  • How to find Water at the Bentley LEARNing Conference May 13-16?

    Here is a list of the water sessions going on at this year's Bentley LEARNing Conference in Phili! BCW2LC1 ‐ Introduction to Bentley Hydraulics and Hydrology Products Tues 2-2:45 pm Lead by H&H AE, Mike Rosh …
  • WaterCAD age calculation fails

    I have run into a recent problem. I've been trying to do a age calculation on our water system and for some reason the largest duration I can calculate is 128 hrs. If I change it to 129 hrs the calculation fails and I get an error: Calculation Engine…
  • Unusual Flow Results

    I'm getting some unusual results and am unable to find a solution. I'm trying to better calibrate our model near an area where 2 pressure zones meet. I've performed a fire flow analysis and tried to confirm the pressures and flow in that area. A flow…
  • Re: Watercad - Looped System Modeling

    Great answers Kim, I have a few approaches to add - first let me rank the approaches in preference. 1) The full model with all controls is always best to determine the most accurate performance (this involves a good deal of set up, controls, and…
  • Reporting the Physical Properties of a Junction

    Hi All, i'm writing a C# code using WaterObjects.NET to report for every junction its Physical properties : (elevator, areas, emitter coefficent). Which classes/feaures may help me? For example from the programming manual i found that scenarios…