• how to find wall thickness and class of Galvanised iron pipe?

    can i find wall thickness in watergems or i have to take the help of hammer. how to design the pipe for particular grade( like mserw grades (grade a or grade b or X42)) or class (like Gallvanised iron (light , medium and heavy class) in watergems…
  • How to model discharge to atmosphere point

    HI, I'm working on my college project (The project is a plumbing system to drain a 1-m3 tank in the shortest time ). I use the discharge to atmosphere element at the end of the project but I'm really confused with this element's input data like [Flow…
  • WaterGems VSD Pumps in Parralel and error message 41797

    I am using Watergems V8i series 3, and trying to model a pump station with two identical VSD pumps in parallel. When I set the pumps up in parrallel, i.e. by just making them have a common node on either side of the pumps, the system balances but only…
  • Water Distribution Modeling Software Survey

    Hello, If you have a few minutes please fill out this short survey to help the Bentley Institute Geospatial team create better training that is more suited to the workflow of our users. http://www.surveygizmo.com/s3/568508/Water-Distribution-Modeling…
  • Distribution Sytem Wide Hammer and Transient Analysis of RPZ

    I am attempting to set up a model to demonstrate how a RPZ (Reduced Pressure Principle Backflow Preventer) will respond to Hammer. For those unfamiliar with the operation of an RPZ, I have attached a document which outlines this very well. …
  • Initial conditions,KNOWN water level in the tank in every time step

    Regards to all. The existing water supply network belongs to III elevation zones of much larger water supply system and ends with the tank of III elevation zone. It is necessary to design new water supply network of IV elevation zone. In the…