Bentley Communities
Site
Search
User
Site
Search
User
Product Communities
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
Sign In
All tags
WaterGEMS V8i
Hydraulics and Hydrology
analysis
Average Demand Calculation
Bentley Water
Demand
Demands
EPS
fire flow
fire hydrant
Fireflow
HAMMER
hydraulics
Junction
junction to hydrants
Pumps
Tanks
water
water distribution
Water Modeling
WaterCAD
Watercad #watergems
WaterCAD V8i
WaterCAD WaterGEMS HAMMER ArcGIS AutoCAD
WaterCADGEMS V8i
WaterGEMS
Best way to duplicate waterlines and junctions for correct demand input
Hannah Pollock
I need to duplicate some pipelines and junctions in my model. The water leads connecting the waterlines to adjacent lots are only represented by one line when there should be two. Trying to input the correct demand (gpm) without just doubling the demand…
Answered
over 2 years ago
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
How to attach an existing junction on an existing pipe line?
Engineer Sifi
I am working on a model in which many of the junctions are not on the existing pipeline. So, I want to attach the existing junction(which is not attached to the pipeline) to the existing pipeline by not creating a new junction on the pipeline and splitting…
Answered
over 2 years ago
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
Low pressure and high velocity
Ragavendra V
Hi, I am a doing modelling for improvement of the existing system. Many location velocities are high and pressure is low. Even I tried to increase the pump capacity the pressure is not increased. Please check the model in the below following link…
over 3 years ago
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
No Flow in tank Top inlet fill
Ragavendra V
Hi, I have another issue in the model, If you check the T-1 inlet it was connected as a top inlet. When I run the simulation for avg daily demand I don't have any issue. However, when I run the same model with Max daily demand scenario (Peak factor…
Answered
over 3 years ago
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
Average Demand Calculation and Fire Flow
Mayowa
My model is fine and everything works fine however the design criteria for demand is 2.1 multiply by the average demand + Fire Flow (as indicated in the snapshot) I have setup the Scenarios and alternative for this criteria based on the BASED DEMAND…
over 9 years ago
OpenFlows | Water Infrastructure
OpenFlows | Water Infrastructure Forum
View related content throughout OpenFlows | Water Infrastructure
More
Cancel