• Is it possible to design unknown conduit/manhole inverts while maintaining conduit diameter and other hydraulic elements?

    I have a existing model which contains sections with unknown conduit/manhole invert elevations, but the conduit diameter is known. I want to apply minimum slope relative to their known diameter to these sections in order to obtain inverts.
  • ModelBuilder from SHP: Only 6" Pipe Was Added

    Hello, I created a model with ModelBuilder, specifying a Data Souorce of ESRI Shapefile (Pipe.shp). That Pipe.shp contains 3, 4, 6, 8, 10, 12, 16, 20, and 24 inch diameter pipes. Problem is, only 6" diameter pipe were added to the model. Is there…
  • the pipe diameters are unconfigured

    what happened here someone help me how to make the topology remain the same ... the entire project was deconfigured
  • RE: Diameter (Dipping Tube) and Variable Elevation Curve.

    Saliha, All the values in the diameter equivalent column need to be greater than 0.3 (300 mm), which is the diameter of the dipping tube. Row 10 and row 3 in the variable elevation curve need to be larger. Regards,
  • StormCAD Flex Tables showing incorrect data

    The diameter of a few of my conduits in my model are not showing up in the Flex Table as the same diameter that is input into the physical properties of the conduit. For example, when I am looking at the properties window under "Physical" the "SectionSize…
  • Re: Odd pipe diameters

    Here's an entry from the WaterGEMS Modeling FAQ : Should I use the inside diameter or outside diameter for the "diameter" field for my pipes? WaterCAD and WaterGEMS use the inside diameter (ID) for calculations. So, you should enter the…
  • Re: Odd pipe diameters

    Initially I thought this was going to be a unit conversion thing (i.e. someone entered these as 6 inch pipes and then converted to mm), but that doesn't work out. It's unlikely that it was a unit conversion error within the WaterCAD software itself…