You are currently reviewing an older revision of this page.
When do I use transition time or warm up time for the Start Type in the calculation options?Problem ID#: 51848
Each system responds to calculation options differently. By default the engine assumes a dry condition to start the simulation; i.e., all inflows are zero and all depths are zero in all elements at the beginning. For situations in which the user wants a non-zero starting flow or the catchments’ hydrology calculations to give none-zero flows, the model provides two options to start the simulation: select Warm Up Time for a warm-up start or Transition Start for a transitional start.
In a warm-up start, the model estimates initial depths based on non-zero inflows and uses a user-specified warm-up time (entered in the Warm Up Time field) to approach steady state conditions prior to starting the actual simulation. In a transition start, the model initiates the simulation from zero flows and immediately reaches the actual none-zero flows in the first time step and continued the simulation.
Note that if the model is a looped network then the warm-up start will be disabled, because of the difficulty in estimating the non-zero initial conditions for complex looped networks. If you experience initial instability in the model and different warm up times don't make the results better, try transition start. If a warm up time of up to a few hours doesn't help, it is probably not reasonable to increase it further. You can read more about the process of tweaking calculation options in the Help topic "Troubleshooting Dynamic Wave model Calculations" or the link in the See Also section below.
Troubleshooting unstable SewerGEMS and CivilStorm results using the Implicit solver