You are currently reviewing an older revision of this page.
A SCADA element is an element created in order to link model elements.The SCADA element must be linked to a model element and can also be linked to some type of external signal. Each SCADA element has only one property so that an element with multiple properties must have one element per property (e.g. a pump with suction and discharge pressure and flow would have three SCADA elements).These elements can be used to display external data in a model or set up alarms for model results.
From the layout tool bar click on SCADA Element icon and then click on the drawing next to the element of interest. One SCADA Element can be mapped to one SCADA tag/item so if there are multiple signals for an element multiple SCADA Element are required, for e.g. if a pump has two signals from SCADA representing flow and pressure then to map both of the signals there must be two SCADA Elements.
Once the SCADA Elements are placed, double click the Element to bring up its properties. Model Element - Click on the drop-down and select the target element. Field - Click on the drop-down and select the type of the data that the signal represents.Real-time Signal - Click on the drop-down and select the signal that represents the field selection above. The list of the signals in this field is tied to the signals visible in SCADA Signal Editor.Historical Signal - Click on the drop-down and select the signal that holds the historic information.Active Alarms - In this field there are several drop-downs which after selecting shows different options to enter. Corresponding to the values defined, Alarms tab in User Notifications window will update. For more on Alarms see the Alarms section below
The SCADA data can be viewed in the graph manager as well. Simply right click on the SCADA Element and then Graph. Click OK on the Graph Series Options window and a graph will be displayed. Note: generating graph for Real-time may not be as valuable as the historic data as there may be only one data value at a given time for a signal. If data are not visible in the graph then please refer to this FAQ.
SCADA Elements can be color-coded based on its value just like the other modeling element. From View > Element Symbology window, right click on SCADA Element > New > Color-Coding and then populate the window as necessary.
Similar to other modeling elements, SCADA Elements can also be annotated, that means the SCADA data value can be viewed in the drawing very easily. From View > Element Symbology window, right click on SCADA Element > New > Annotation . In the Annotation window, populate the necessary field and then click Apply and OK.
In this Flex table, all the SCADA Signal that are mapped in the drawing are visible. This flex table shares all the features that other flex tables offers. Flex Table can be view from View > Flex Tables then double click on SCADA Element Table. The same table can also be viewed from Report > Element Tables > SCADA Element.
Alarms are tied only to SCADA Elements however Alerts are tied to all elements. There are four types of Alarms that SCADA Element can raise, • High Only one value can be provided. When corresponding modeling element value is higher than the given value, this alarm is triggered. • Low Only one value can be provided. When corresponding modeling element value is lower than the given value, this alarm is triggered. • Low, High Two values can be provided. • Low-Low, Low, High, High-High Four values can be providedAll the Alarms are listed in the Alerts and Alarms tab of the User Notifications window which can be obtained from Analysis > User Notifications
For information on use of SCADAConnect Simulator and the publishing ability in SCADAConnect Simulator, please refer to the following link: SCADAConnect Simulator