You are currently reviewing an older revision of this page.
How can I use the customer meter element demands with Darwin Calibrator?
Or
How can I take demand data from customer meter elements and enter it quickly into my other node elements, such as junctions, hydrants, or tanks?
With the initial release of SELECTseries 5, Darwin Calibrator and Darwin Designer only considered demands that were placed on a junction, hydrant, or tank elements. An update was made available after release, to support the use of the Customer Meter element with Calibrator and Designer. Without this patch, demands from customer meters will not be considered in Calibrator or Designer.
This update will be available in the next release and in SELECTseries 5 cumulative patch sets dated after December 2014. For information on downloading cumulative patch sets, please see the below article. If further assistance is needed, please contact technical support or post to the Hydraulics and Hydrology forum.
How do I download WaterGEMS, WaterCAD, HAMMER, SewerGEMS, SewerCAD, CivilStorm, StormCAD, PondPack, FlowMaster, CulvertMaster
Updating your version/patch is the ideal solution, but if you would like to convert your customer meter demands to junctions, consider the below steps:
1) Download the attached Excel spreadsheet
https://bentley.sharefile.com/d/sc3b67ab5c9948139
2) Open it and become familiar with it
3) Open Modelbuilder (Tools > Modelbuilder) and on step 1 choose Excel 2013/2010/2007 (12.0) as the data source type then click the next button.
4) On step two set accept the defaults because this information will not matter for what we are doing. Do the same thing for steps 3 and 4.
5) The field matching you do for step 5 will depend on what information you have entered in your customer meter element. In the screen shot below the example shows how you would go about doing the field matching for most properties of the customer meter element. If you only need to export certain information like customer meter Label and Demand (Base) you don't need to field map all the other columns.
6) On step 6 when asked if you "Would like to build a model now?" choose 'No' and hit the Finish button.
7) On the main Modelbuilder manager make sure the new sheet you created is highlighted in blue by single clicking on it and then hit the "Sync Out Button", which is the button to the left of the question mark icon (Help Button). This will export all your customer meter information to your spreadsheet.
8) Now double click on the Modelbuilder run you created to reopen the Modelbuilder Wizard. Follow the directions in this wiki that explains how to import demands from a spreadsheet to you node elements.
https://communities.bentley.com/Products/Hydraulics___Hydrology/w/Hydraulics_and_Hydrology__Wiki/importing-demands-from-a-spreadsheet