You are currently reviewing an older revision of this page.
You have done the manual run using Darwin Calibrator, but the results of the exported solution do not match the model.
In order to match the results that you are getting from Simulated Results tab in Calibrator (see image below) you will need to do the following:
In your model you will need to set your calculation options as follows:
Setting the calculation option for “Is EPS Snapshot? = True ensures that your model is going to use the pattern multiplier that Calibrator used when doing its calculations.
After the changes are made to the scenario, compute it, and look at the properties of the observed target in your model to make sure it matches the simulated results in Calibrator.
Using Darwin Calibrator
In Darwin Calibrator why are my original demands on the solutions tab not matching with the demands entered in the demand control center?
Product TechNotes and FAQs
Haestad Methods Product Tech Notes And FAQs
General WaterGEMS V8 FAQ
Bentley LEARN Server