You are currently reviewing an older revision of this page.
You have done the manual run using Darwin Calibrator, but the results do not match the model.
In order to match the results that you are getting from Simulated Results tab in Calibrator (see image below) you will need to do the following:
In your model you will need to set your calculation options as follows:
Setting the calculation option for “Is EPS Snapshot? = True ensures that your model is going to use the pattern multiplier that Calibrator used when doing its calculations.
After you make all these changes to the scenario in your model just compute and look at the properties of the observed target in your model to make sure it matches the simulated results in Calibrator.
In Darwin Calibrator why are my original demand results on the solutions tab not matching with the original demands that I have entered in the demand control center?
Using_Darwin_Calibrator
Product TechNotes and FAQs
Haestad Methods Product Tech Notes And FAQs
General WaterGEMS V8 FAQ
Bentley Technical Support KnowledgeBase
Bentley LEARN Server