Product(s):	WaterGEMS, WaterCAD
Version(s):	CONNECT Edition, V8i
Area:	Modeling

This is a list of articles containing general information on Automated fire flow for WaterGEMS and WaterCAD.

How does the Automated Fire Flow analysis work?

Understanding Automated Fire Flow Results

Why do I see "N/A" for all fire flow nodes in the Fire Flow Node Table? 

How do I remove the "N/A" entries in the Fire Flow Node Table for nodes not included in my Fire Flow Nodes selection set? 

Fire flow nodes are failing because of low pressures on the suction side of a pump

Using the Fire Flow Results Browser to view hydraulic results during a fire flow in FlexTables and Properties

Reporting pressure available at the exact total needed fire flow

Using hydrant flow curves to check residual pressure for a range of flow

Understanding the "Fire Flow (Needed)" and "Fire Flow (Upper Limit)" Fields for a Fire Flow Analysis 

See Also

OpenFlows Product Tech Notes And FAQs

WaterGEMS and WaterCAD TechNotes and FAQs

OpenFlows | Hydraulics and Hydrology Forum