You are currently reviewing an older revision of this page.
This is a list of articles containing general information on Automated fire flow for WaterGEMS and WaterCAD.
How does the Automated Fire Flow analysis work?
Understanding Automated Fire Flow Results
Why do I see "N/A" for all fire flow nodes in the Fire Flow Node Table?
How do I remove the "N/A" entries in the Fire Flow Node Table for nodes not included in my Fire Flow Nodes selection set?
Fire flow nodes are failing because of low pressures on the suction side of a pump
Using the Fire Flow Results Browser used for to view hydraulic results during a fire flow in FlexTables and Properties
Reporting pressure available at the exact total needed fire flow
Is there an easier way to check residual pressures at a hydrant for a range of flows?
Understanding the "Fire Flow (Needed)" and "Fire Flow (Upper Limit)" Fields for a Fire Flow Analysis
OpenFlows Product Tech Notes And FAQs
WaterGEMS and WaterGEMS TechNotes and FAQs
OpenFlows | Hydraulics and Hydrology Forum