You are currently reviewing an older revision of this page.
The Property connection element was introduced in the CONNECT Edition (10.00.00.40) and is used to load sewer models based on data at the level of individual properties. This is useful when you have loading data provided for all customers/properties based on metering, number of occupants/fixture units, or simply flow per property, and you would like to see it in your hydraulic model (rather than lumping all loads into manholes). This can also enable a closer 1:1 match between the hydraulic model and a GIS.
A Property Connection can be placed manually in a model by selecting Layout, then either Property Connection or Lateral.
Property connections can be connected to a downstream gravity network using lateral links. Laterals connect to tap elements and most gravity nodes such as manholes, transitions, and catch basins. Taps can connect to conduits, channels and manholes.
Property connections cannot be connected to pressure elements. Laterals can only make a single connection to a tap or other hydraulic element. Taps cannot connect to a conduit that is designated as a diversion link. There cannot be any hydraulic elements on the upstream side of a Property Connection. However, a Property Connection can be the Outflow Element for a catchment.
The flows from each lateral are assumed to enter the network at the upstream end of the connected conduit in the GVF-Rational and GVF-Convex solvers, and at the Tap node in the Explicit (SWMM) solver. They are not supported in the Implicit (DW) solver.
Option 1: A Property Connection can be placed manually in a model by selecting Layout, then either Property Connection or Lateral. The load data for each Property Connection can then be entered in the properties grid or FlexTable.
Option 2: Create Property Connection elements via ModelBuilder, with the loading data attached to the data source. Then use LoadBuilder to assign the property connection flows to the nearest element.
LoadBuilder can be used to assign isolated Property Connection elements to the nearest element by creating a tap and lateral connection. Isolated Property Connections are those elements that are not connected to any lateral element. Laterals are automatically placed between the source element and the hydraulic network when using LoadBuilder and selecting Property Connection Load Data as the Available LoadBuilder Method. When this data source is used, it is assumed that that load data is already available in the Property Connection.
When using the Nearest Pipe method, if the property connection is within 10 feet of a manhole node (perpendicularly), it will be assigned directly to that node directly instead of the pipe. One common situation where this occurs is at a cul-de-sac.
For steps detailing this process, see the following article:Using LoadBuilder to assign Property Connections to the nearest element while creating taps and/or laterals
In version 10.00.00.40, lateral link elements count toward your total number of pipes/links, which is checked against the number of available pipes in your license.
In future versions above 10.00.00.40, laterals should NOT count toward your license limit.
Elevation of the ground and the lateral invert can be placed in the attributes of the Property Connection element but are not used in the hydraulic calculations. It is not possible to construct a profile through a lateral link and up to a Property Connection.
Property connections are used for loading in the Explicit and GVF Convex solvers, but not the Implicit solver. Property connections support hydrograph inflows, pattern loads, or directly accept runoff as the outlet of a catchment. For the GVF Rational Solver, flow through a Property Connection must come from a Catchment. (Property Connection designated as the Outflow Element.)
The query "Property Connections not connected to Nearest Link" is included in the Network Review Predefined Queries (version 10.00.00.40 and later). This is useful to locate property connections whose loads did not get assigned or are assigned to a pipe that is not closest. To locate completely disconnected property connections, use the query "Orphaned nodes".
Using LoadBuilder to assign Property Connections to the nearest element and create taps and laterals
Introducing individual Property Connections to your model [VID]
How to toggle tap node dashed line display
Help Article "Property Connections"