Error message: The last multiplier in a pattern must match the starting multiplier

Product(s): WaterGEMS, WaterCAD, SewerGEMS, SewerCAD, CivilStorm, HAMMER
Version(s): CONNECT Edition, V8i
Area: Modeling

Problem

When computing or validating a model, the following error message is generated: "The last multiplier in a pattern must match the starting multiplier."

Solution

This issue occurs when the last multiplier in a pattern does not match the starting multiplier for the pattern. The first and last multiplier must match to ensure that the pattern can repeat if the model run time is longer than the pattern.

To fix the issue, check the starting multiplier at the top of the Patterns manager and make sure this is the same as the last multiplier in the pattern. The example below shows an example of the starting and ending multiplier being different. Notice the error message at the bottom of the dialog.

If last multiplier is changes to match the starting multiplier, the error will no longer occur.

See Also

Import Demand and Loading Patterns using ModelBuilder

  • Created by Bentley Colleague
  • When: Wed, Mar 3 2021 10:41 AM
  • Revisions: 1
  • Comments: 0
Recommended
Related