Cannot Change Level Display in DWG Reference

Hi Everyone,

One of our users has reported an issue while attempting to adjust the level display of a DWG reference file. 

All the reference levels are grayed out and cannot be adjusted. This occurs when the DWG file is attached

to another DWG file. If the DWG file is attached to a DGN file there is no issue and one can adjust the DWG

reference levels display. This happens in Microstation SELECTseries 4.

Any ideas?

Regards,

Benzi

Parents
  • This may be associated with the operation of the configuration variable MS_LEVEL_EDIT_NESTED_ATTACHMENT_LEVELS where by default it can disallow you to make modifications to nested reference file levels. If this is working ok when the same DWG is referenced into a DGN file than it could be that the capability may have been disallowed in their configuration files. It may be worth looking in the users User or Project Configuration files (UCF or PCF). for any settings relating to this.

       Regards
       Andrew Bell

Reply
  • This may be associated with the operation of the configuration variable MS_LEVEL_EDIT_NESTED_ATTACHMENT_LEVELS where by default it can disallow you to make modifications to nested reference file levels. If this is working ok when the same DWG is referenced into a DGN file than it could be that the capability may have been disallowed in their configuration files. It may be worth looking in the users User or Project Configuration files (UCF or PCF). for any settings relating to this.

       Regards
       Andrew Bell

Children