HI
When I export to DWG some of my pattern disappears if I choose to use the fence as filter. I have the exact same settings in both cases, except of the fence. I also tried placing a gaint fence really far zoomed out, but it didn't help.
Export with fence:
Export without fence:
How could this be?
Running AECOsim connect update 4, equal to microstation connect update 11.
Regards,
Robert
While I have no actual knowledge whatsoever...
Is this the only drawing this happens to, or does it happen to all your drawings?I wonder if there isn't some pattern control element that's getting clipped "off" by the fence.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
I'll try and get back to you on this.
That was one of my thought as well. That's why I created a giant fence, but that didn't work either.
DWG SaveAs Options has a View number. Have you set that to the view where you placed the fence?
Can't find that option. But ecerything outside the fence is not exported so it should be correct. Also, if I open all 8 views, I can see the pattern in every one of them.
In your DWG Save Options Is your Fence Mode: set to 'Inside ? What happens if you change this to say Overlap or Clip ?
Overlap seem to work, but not inside or clip.
Thanks for testing, I have reproduced a similar/same scenario and filed Defect 1009494.
In addition I have logged a Service Request on your behalf and will send you an email requesting the files used in your case so these can be evaluated against this defect.