HiI'm wondering if the AccuDraw command "R+V" (rotate view) have been removed in MicroStation CONNECT?
I'm usually using the command when I want to rotate my drawing from top view to see the drawing
from a straight angle. You can see how I did it in the previous versions of MicroStation below.
Step 1. I snap on one of the corner of the block
Step 2. I press "O" to set the origin of the AccuDraw where I have snapped.
Step 3. I press "R+Q" (rotate quick) to set the right angle for the drawing to be straight
Step 4. At that point, I use the "R+V" command, after that I'll see my drawing straight.
If the command is gone, then my next question is, do you have any good idea how to do this in another way?
It seems AccuDraw rotate view shortcut is just using "V" now rather than "R+V".
RegardsAndrew BellTechnical SupportBentley Systems
Hi Andrew!
A single V just align AccuDraw to the view, not the whole view.
The shortcut RV exist in V8i:
If I select Edit... on RV I can see the key-in for it:
I can add it to the shortcut-list in Connect and it works:
I wish it would be added to the standard installation of MS Connect.
Regards Håkan
Defect Report # 163516 was previously raised to address a number of shortcuts keys not available in AccuDraw Shortcuts but was deemed to be "As Designed" by our development team. ----------- Below mentioned shortcuts are neither available in ‘Keyboard Shortcuts’ nor alternative shortcut keys available. LP = Lock ACS Grid Plane LA = Lock ACS Plane LS = Lock ACS Plane Snap RV = Rotate View GT = Go to Tool Settings GK = Go to Key-in HS = AccuSnap Toggle HU = AccuSnap Suspend -----------