Connect - AccuDraw: Where´s the short-cut (R+V) gone?

Hi

I'm wondering if the AccuDraw command "R+V" (rotate view) have been removed in MicroStation CONNECT?

I'm usually using the command when I want to rotate my drawing from top view to see the drawing

from a straight angle. You can see how I did it in the previous versions of MicroStation below.

 

 

Step 1. I snap on one of the corner of the block

Step 2. I press "O" to set the origin of the AccuDraw where I have snapped.

Step 3. I press "R+Q" (rotate quick) to set the right angle for the drawing to be straight

Step 4. At that point, I use the "R+V" command, after that I'll see my drawing straight.

 

If the command is gone, then my next question is, do you have any good idea how to do this in another way?

Parents Reply
  • Defect Report # 163516 was previously raised to address a number of shortcuts keys not available in AccuDraw Shortcuts but was deemed to be "As Designed" by our development team.

    -----------
    Below mentioned shortcuts are neither available in ‘Keyboard Shortcuts’ nor alternative shortcut keys available.
    LP = Lock ACS Grid Plane
    LA = Lock ACS Plane
    LS = Lock ACS Plane Snap

    RV = Rotate View

    GT = Go to Tool Settings
    GK = Go to Key-in
    HS = AccuSnap Toggle
    HU = AccuSnap Suspend
    -----------

    Regards
    Andrew Bell
    Technical Support
    Bentley Systems

Children