Connect - AccuDraw: Where´s the short-cut (R+V) gone?

Hi

I'm wondering if the AccuDraw command "R+V" (rotate view) have been removed in MicroStation CONNECT?

I'm usually using the command when I want to rotate my drawing from top view to see the drawing

from a straight angle. You can see how I did it in the previous versions of MicroStation below.

 

 

Step 1. I snap on one of the corner of the block

Step 2. I press "O" to set the origin of the AccuDraw where I have snapped.

Step 3. I press "R+Q" (rotate quick) to set the right angle for the drawing to be straight

Step 4. At that point, I use the "R+V" command, after that I'll see my drawing straight.

 

If the command is gone, then my next question is, do you have any good idea how to do this in another way?

Parents Reply Children
No Data