Why when I open a 2d seed file and try to draw a line, the line only draws at certain angles and line dissappears into the back of the view port. I am familiar with Microstation but a newbie when it comes to the initial workspace setup.
Microstation V8I select series 4. There is no active angle and length lock turned on. attached is a drawing that I had and shows what the program is doing.
Looks like the old Graphics Card update issue.
https://communities.bentley.com/products/microstation/w/microstation__wiki/13543/troubleshooting-graphics-display-issues
I Hope This Helps Someone Reading This! (Intergraph>PseudoStation>MicroStation user since 1980's)
Unfortunatly the link dosen't resolve the issue. Bentley should update this.
If working in Windows 10 you can't try older graphic drivers.
So the fastest and easet way it to do a debug using windows environment to make Microstation use DX9 instead of DX11. Or you can do that inside Microstation - Workspace - Configuration - QV_DISABLE_D3D11=1.
If not want to do the step by step you can use this file:
communities.bentley.com/.../272103
Regards
José