Full screen width cursor disappears

Question

I have powerdraft select series 3 8 11 9 397 
 
 I use the full screen width cross haired cursor, which enables freehand alignment to objects 
 on a not nearby part of the screen. 
 When I use the arrow powerselector to move an object, cross hairs are there, but disappear 
 as soon as the object is moved. 
 So the cross hairs cannot be used; they are not there during the movement.Whis is exactly when 
 they are needed,When the movement ceases and the mouse is released, they come back again. 
 
 So, trial and error is needed, to use the crosshairs. 
 
 How can this rather unintelligent behaviour be curbed, to the blessed things remain visible 
 when needed??

Jose Pinho · Answer

Jim Medlock said: So, trial and error is needed, to use the crosshairs. 
 After you select your object then use the move command (or the other way around), make sure you highlight your accudraw and press ENTER to make the movement orthogonal. So, no need for full screen cursor. 
 
 Use help to get you along, you should master accudraw to make things fast and right. 
 And of course you should use Snaps to make sure everything is connected the right way: 
 
 This will help you start: 
 https://communities.bentley.com/products/microstation/w/microstation__wiki/11392/drawing-aids---microstation 
 Regards

Ron Jones · Answer

Hi Jim, 
 Assign the following key-in to a function key. 
 MOVE;DL=;/d;/d;RESET 
 After selecting the element, press the function key to move the current selection while displaying the full screen cursor. 
 Regards, Ron