Hello good MS community,
Here's a question taht I've been trying to figure out, or maybe know if you're able to do it.
When you place a filled shape, such as rectangle or circle, you always get it filled, even when you're selectiong tyhe Fill Type: None.
Is there a way to just make the rectangle or the circle without any solid filled pattern?
Regards
Your view presentation needs set to Wireframe
Connect r17 10.17.2.61 self-employed-Unpaid Beta tester for Bentley
that is where I was going with this. I agree with Bob and am guessing your display presentation is not set to wireframe, but at least wanted to make sure of the obvious first.
Timothy Hickman
CADD Manager | CADD Department
timothy.hickman@colliersengineering.com
Main: 877 627 3772|
1000 Waterview Drive Suite 201 | Hamilton, New Jersey 08691