I want to move a reference -500' on the xplane but I am a little confused how to get the Batch Process to pick it up. I have the move reference keyin but I am unsure how to tell it to move 500'. It is a basic question that I hope someone can answer for me. Thanks in advance!
The distance keyin you're looking for is DX = -500,0
so at the point you need to put in starting point and ending point, you could add
XY = 0,0DX = -500, 0
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
No didn't work for me. Maybe I didn't explain right, I am trying to move the reference 500' to the right, so x=-500. When I try adding this below my reference move keyin it moves the reference over a thousand feet in the negative y direction. And I have to use the cursor to finish the command. Ideally the process would just move it to the right 500' without extra input.
Is your view rotated, or is this unrotated X & Y?
I forgot that DX is along the view axes. The full keyin for DX = x,y is POINT VDELTA x,y
If you want to go along the design axes, you will want DL = x,y. The full keyin for that command is POINT DELTA x,y
If you want to move by distance and angle, you would use DI = d,a. The full keyin for that is POINT DISTANCE d,a
You may need to select a view for the function to complete. you can add ;SELVIEW 1 to the end of your keyin. That might help.
Actually, if you go to the Help file and search for DX, you will get the page for precision input keyins. You may well find the information you need there.
that didnt work either, ill look into DX like you recommended and hopefully find the magic number to move the reference lol