MS_REF_NEWLEVELDISPLAY Key In not working

I've seen users previously ask about new levels not being turned on from a reference and I've read for V8i you should use the key in MS_REF_NEWLEVELDISPLAY and set it to 1. My Key In does not accept the command and doesn't recognise it. Any ideas as to why ? and how I can fix this.

I have the situation where the levels aren't turned on but I also have the situation where the levels are on but you can't see anything. Both drawings have the same reference source.

Parents
  • Duncan is correct - MS_REF_NEWLEVELDISPLAY is a configuration variable that needs to be set somewhere in your standards configuration.

    Also, when you are checking if a level is "on", remember that there are three "types" of on/off that you can control from the Level Display dialog: View Display, Global Display & Global Freeze. A level needs to be on in all three to be visible.

    MaryB

    Power GeoPak 08.11.09.918
    Power InRoads 08.11.09.918
    OpenRoads Designer 2021 R2

        

Reply
  • Duncan is correct - MS_REF_NEWLEVELDISPLAY is a configuration variable that needs to be set somewhere in your standards configuration.

    Also, when you are checking if a level is "on", remember that there are three "types" of on/off that you can control from the Level Display dialog: View Display, Global Display & Global Freeze. A level needs to be on in all three to be visible.

    MaryB

    Power GeoPak 08.11.09.918
    Power InRoads 08.11.09.918
    OpenRoads Designer 2021 R2

        

Children
No Data