Dynamic sections depth of view

Hi all,

I have cut a section through a 3d model. I would like to set different depths of view along the cut line. is this possible?

Thanks

Parents
  • In addition to John's suggestion, another couple of methods that may be of help

    1. Divide the cut line into several clip volumes and reference these into the same sheet, reposition to align boundaries. Then adjust the depth of each as required. In the following example the middle clip volume depth is reduced so the red cylinder is not displayed.

    2. Create a step (right click on section line) in the cut line rather than adjusting the depth.

    3. Reference the 3D model into an empty file, clip mask the reference areas not required, before creating section.



    Answer Verified By: Euan Rankin 

Reply Children