Sorry if this is in the wrong section. I have not used this forum in quite some time, and the interface has changed to the point that I can't figure out where to post general MicroStation questions.
Here is the problem - which I have had for quite some time. When using Microstation V 8.11.09.608 on a Windows 10 machine. The View Toolbox appears, then after sing the program for a little while the tools disappear. If I close the view window, and re-open it, the View Toolbox reappears. I can't tell if this is a graphics card issue, a Mstation setting, or a windows bug? I don't have this problem in any other program, but then again, I can't think of another program that has this feature?
Any suggestions appreciated.
I'm not sure if you can see this, I Here is the sequence. I have my file open - with view 1 on top of view 2. If I switch to View 2, then back to View 1 - all the "view controls" are gone, and there is a black bar on the window where the controls would have been.
This screen shot is right after I pulled view 1 back on top of view 2.
Try setting QV_D3DVERSION=9
Here is a link discussing some of this: