Display Style not working in reference file

Microstation Connect Edition, Update 12

I have created a Display Style with the following conditions:

- Element is Shape

- Element is color = 2

When theese conditions are met and the Display Style is used, the element has to be shown with a pattern inside the shape.
This I have configured via the Actions and the pattern I use is taken from a cell library.

Here is my issue.

If I draw a shape element with the color = 2 and apply the Display Style, the shape element is displayed as wished.
But if I attach a reference file where there is a shape element with color = 2 and apply the Display Style, the element will not be shown with cell pattern inside. why is this..??

Hope someone has some advise.

Thanks

Parents Reply
  • Hi,

    Has there been any work done to sort out this defect?

    I have checked in OpenRoads Designer 2022R1 (10.11.00.115) which is based on Power Platform V10.17.00.990 and Display Rules with cell patterning applied to references still don't work. I have tested very similar setup as Morten described here except the condition included shapes on specific level name. Same Display Rule works fine on a model physically located in the active file.

    Interestingly hatch and crosshatch appears to wok fine in reference. So, its only pattering causing problem.

    Ability to re-symbolize elements in references is critically important for workflows efficiency.

    Regards,

    Mariusz


    OpenRoads Designer 2022 R1

Children
No Data