However, it seems that in Connect the "View previous"-command is limited to 20 steps.
In V8i I cannot recall such a restricting limitation. Is it possible to go further back than only 20 steps?
Andras Dähnrich said:Is it possible to go further back than only 20 steps?
It's not possible. The 20 limit was chosen because it seemed like a reasonably high number that didn't needlessly waste memory for view delta states that would never be accessed.
Instead of clicking view undo more than 20 times, you might want to consider creating some saved views?
HTH
-B
So something was possible in 32bit V8i became impossible in 64bit CE. Such improvement.
Tuan Le said:V8i recommended memory is 4GB, while CE recommended memory is 16GB, and we worry about memory?
Yes, we want you to have as much memory available as possible for your design data without swapping to virtual memory.
Tuan Le said:Critical improvements that have been requested for eons were never acted upon. While "trivial" things I couldn't care less about seem to get all the attention and effort.
I remember when users were screaming about how slow MicroStation CONNECT was. I see where freeing up memory would help to improve the speed of the product. Within a drawing session, you could have hundreds or thousands of previous view when scrolling to zoom, like Mary pointed out.
I understand why the limit was placed on Zoom Previous but being able to control the limit with a preference setting or variable could be useful. You may want to add it as a suggestion in the "Ideas" area of the communities.
Have you been to the "Ideas" section lately...?It's no longer part of the Bentley Communities (even though they used the logo) and you need to create an account with some third-party provider. The data migration isn't complete and there are plenty of other issues with dates, comments, and status updates.
We could, however, file a service ticket to Support to initiate a request for enhancement. I don't have that authority here, but I'm sure someone out there does.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
Brien Bastings said:Everyone with this concern is welcome to file a support request to be able to override the 20 view undo limit.
Done.
My Service Request number is 7001212366
Thank you!