Unable To Locate Graphical Elements On Design Model

Hello,  I'm looking for some advice on getting rid of a couple of annoying graphical elements that I can't see on the design model.  I have run a CADQA check on one of our

drawings and the results state the following -

Error: element (Element Type106) with id (221506) in model (WB-Drawing Model) found'.
Error: element (Element Type106) with id (234753) in model (WB-Drawing Model) found'.
Error: 2 graphical elements found in the Drawings design model
No elements found on Level '0' or 'Default'.

 

The problem is that I can't see the '2 graphical elements' that it is referring to.  I'm very knowledgeable with MicroStation but this one has floored me.  I had something like this

happen before and had a key-in which fixed it in seconds but I can't remember what this was as it was a while ago now.

I've tried all the usual things of removing shared cells, using explorer to look for the elements, searching using their ID number etc.

Does anyone have any advice or know of the key-in which could help?  

I'm using MicroStation Connect version 10.13.00.48

 

Thanks in advance.

Parents
  • Thank you all for your help at the moment.  Still trying to figure it out.  The job is through ProjectWise and is set up with an OS tile etc.  I can't save it out as a DXF or anything.  Interestingly though, when I did the ID search previously it selected a couple of lines on the OS tile which isn't correct as that's referenced in from elsewhere and I can't edit that.  This tile is also on my other drawings which have gone through the checks fine.  When I tried the key-in as per Oto's idea, it selected the two saved views I have....again this can't be correct as the other drawings are set up the same way and don't have this issue.

Reply
  • Thank you all for your help at the moment.  Still trying to figure it out.  The job is through ProjectWise and is set up with an OS tile etc.  I can't save it out as a DXF or anything.  Interestingly though, when I did the ID search previously it selected a couple of lines on the OS tile which isn't correct as that's referenced in from elsewhere and I can't edit that.  This tile is also on my other drawings which have gone through the checks fine.  When I tried the key-in as per Oto's idea, it selected the two saved views I have....again this can't be correct as the other drawings are set up the same way and don't have this issue.

Children
No Data