I am using the same dgn, plt and tbl between XM and 2004. In 2004 the line is above the filled shape as wanted. In XM, it is below the shape. I thought it was coming from the pen table because if I detach the pen table in XM, it looks ok. I have also check priority on the line and the level...both at 0. The microstation view looks fine.
MS 8.9.4.51 & MS 8.5
I noticed in my pen table I have priority Sections set to -1, 0, 1, 2. The priority 1 section contols the screen filled shape and the black lines that should be on top are controlled by the priority 2 section. So that should work
If I adjust these priority numbers down so that they read -5, -4, -3, 2.....then it works. I'm not changing the actual order just the number so that all "bottom" sections are negative. Not sure why it works this way in XM.
Charles (Chuck) Rheault CADD Manager
MDOT State Highway Administration