Print oragniser always crash

MicroStation V8i SS3Up2 what is the latest select released version is not certified for Windows 10.
For the Windows 8, make sure that MicroStation V08.11.09.357 or later version is installed.

Steps to analyze the issue what causes this error, is it the file, the MicroStation installation/configuration or the user printer driver configuration file:

1) Check if the same problem occurs using one of MicroStation example files using one of unmodified default supplied printer driver configuration files. E.g. PDF.PLTCFG
2) Try one print job first.
3) In case this fails, created a new workspace and do step 2 again
4) In case this fails, reinstall MicroStation since the example files should print correctly.

In case MicroStation example files print correctly try the following’
5) Do the same with your file using one of unmodified default supplied printer driver configuration files. E.g. PDF.PLTCFG . Print one print job first.
When not correct, the design file needs a check-up.

6) In case this is correct, do the same with your printer driver configuration file.
When not correct: Most likely this is caused by the printer driver configuration file. Send this file for investigation.

I hope these steps will indicate where the cause of the crash is.

Sorry for my late answer, but many things to do (and learn microstation at fly...).

I found that problem is in DGN from architects, if I have attached this file and want print, it always crash - except one - raster print, this work - but only raster and PDF. Now just find where is problem in DGN from architects...

Sorry for my late answer, but many things to do (and learn microstation at fly...).

I found that problem is in DGN from architects, if I have attached this file and want print, it always crash - except one - raster print, this work - but only raster and PDF. Now just find where is problem in DGN from architects...