Configuration Variable to force the active file to last position in Update Sequence

RE: Configuration Variable to force the active file to last position in Update Sequence

MichaelGilham — Tue, 03 May 2016 04:52:49 GMT

Thanks Andrew and Lorys

RE: Configuration Variable to force the active file to last position in Update Sequence

Lorys — Sat, 30 Apr 2016 01:02:01 GMT

I seem to remember there was a config variable that forces this in msnt so its alway by default and then its not controlled by printing it just works itself out..

I 'll look it up and get back to you... later,,,

Well ....

I'm back now

There is a way to do it in your config but it only works on new files so you have to set the variables before you make a new drawing..

but if you do set the variable (s) then any new drawing created post variable will always have the active on top.. ie last

see full discussion link below

communities.bentley.com/.../how-update-sequence-of-active-model-and-reference-attachments

brief discussion and only one variable link below

communities.bentley.com/.../force-new-design-models-to-always-be-drawn-on-top-of-references

RE: Configuration Variable to force the active file to last position in Update Sequence

Andrew Bell — Fri, 29 Apr 2016 05:43:25 GMT

From what you are describing I would think this would be achieved in a Pen Table in something like the Processing Order.

Assigning this to the Printing and Plotting forum.