I have drawings with a certain linestyle pictured below. When I print from the microstation print dialog the linestyle shows up how it is supposed to. When I print from the print organizer it prints as just a line with no style associated. I have tried changing the display setting in the print organizer and nothing works. The print driver/pentable for the print dialog are exactly the same. Any ideas on why this is happening? I'm trying to figure this out so all of our sheets can be printed from the organizer instead of having to do some individually. I've attached all relevant items.
In Microstation drawing:
PDFPDF
Taylor,
Have you found an answer to this issue? I'm having the same problem. Thanks
God bless,
David
David Sullivan
Engineering Software Support Engineer
MS V8i SS2 v08.11.07.492
MS ORD-CE v10.09.00.91
Taylor did verify the Wiki article I linked above as an answer. Might that article apply to your situation?
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
Good Morning MaryB,
Thank you for responding. I did look at that article and we do use a switch in the target but the version of MicroStation V8i that we use (v.08.11.07.492) is after the version that Print Organizer has been fixed for that issue. Plus we have been using the Print Organizer for years without an issue.
The problem I am having is that we have added a few new Line Styles and those are the ones that Print Organizer is not printing to .pdf. Do you have any ideas or direction I could look? I will be posing this question in the Printing and Plotting Forum. Thank you for any help you can offer.
Our microstation is started with the following target: