I am having trouble printing a sheet. I am using print organizer. When I print, there are lines that appear (centerlines, contour lines, flood plain lines) that I have specifically turned off in the base file. After referencing into the sheet file, they are still not visible. I do not know what level they are on or how to access them. However, they still appear when I print. I have tried deleting them from the Pset and re-adding them, and it doesn't fix the problem.
Mike,
If you print 1 file not using Print Organizer (FILE > PRINT) do you still get the ghost lines? Make sure you are using the same pltfg, pen table, design script as print organizer. Print organizer does the same thing as FILE > PRINT (mostly) only faster so usually if it's a problem in PO we usually see the same problem outside of PO.There is a tab in PO that will let you turn off\on levels. That may be worth a quick look too.
Tom F.
I printed without PO and it did the same thing so, I remade the sheets and it fixed it. So I'm not sure what the problem was, because I used the same references and copied over the text.
I've had the occasional corrupt drawing over the years - it happens. At that point, recreating has been my only fix.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2