Hi All,
I'm having a problem when printing to PDF!
Using the pdf.pltcfg, I have turned on "Enable Optional Content" in Driver Properties to get it to create "Layers" in my PDF to match my DGN, no drama there.
My question is how do I get it to not create the Hierarchial folder system as shown below;
my preference is to get it to look like this;
Thanks in advance
David
Hello David,
Currently I can't think of way of doing this, apart from perhaps merging all the reference files to the master.
Jonna,
Thankyou for your response.
As the DGN is made up of a model & a sheet view with no other reference files attached by merging the model into the sheet sort of defeats the purpose of having the 2 in the 1st place. I did try it though and with using the "Merge Layers tool" in Acrobat Pro, was able to get the same result as i did before hand, i.e.
one folder at the top & then all levels directly below. This cuts out the need for the client to have to open multple folders before reaching the "Layers" (levels) to turn off and on.
So there is no solution to this? kinda weird! i have been working on getting this for a day or so and no luck. you would think its in the output settings but i found nothing. if there is anything that may lead to fixing this please post.
So the only way you figured out was that you had to use Acrobat Pro to make the levels look like that?